What each radio supports

The FT-991A and the FTDX101D are tested on real radios (the FTDX101MP has the same commands as the D). FTDX10 and FT-710 are experimental: their profiles were written from the radios' CAT manuals and tested only against a simulator, and the page shows an "experimental" banner. See other radios for what to check first if you have one.

How to read the table:

Mark	Meaning
works	tested on the real FT-991A
from the manual	implemented from the CAT manual, not yet tried on a real radio of that model
from the manual, untested	on the FT-991A too, but not yet tried there
not offered yet	exists in the manual but is switched off until it has been tried on the radio (it can transmit, or its table was wrong on another model)
-	the radio does not have it, or it is not available over CAT

Functions

Function	FT-991A	FTDX10	FTDX101D	FTDX101MP	FT-710
Transmit
Antenna tuner on/off	works	from the manual	works	works	from the manual
Microphone input (menu: MIC / REAR)	works	from the manual	works	works	from the manual
Monitor	works	from the manual	works	works	from the manual
PTT (hold to transmit)	works	from the manual	works	works	from the manual
Speech processor	works	not offered yet	works	works	not offered yet
TUNE (start the tuner: transmits a carrier)	works	not offered yet	works	works	not offered yet
Meters
ALC meter	works	from the manual	works	works	from the manual
Compression meter	works	from the manual	works	works	from the manual
SWR meter	works	from the manual	works	works	from the manual
Receiver
AGC (OFF / FAST / MID / SLOW / AUTO)	works	from the manual	works	works	from the manual
Attenuator (OFF / 6 / 12 / 18 dB)	-	from the manual	works	works	from the manual
Attenuator (on/off)	works	-	-	-	-
Audio peak filter (CW)	not offered yet	not offered yet	not offered yet	not offered yet	not offered yet
Auto notch	works	from the manual	works	works	from the manual
Contour	works	from the manual	works	works	from the manual
Filter width	works	from the manual	works	works	from the manual
IF shift	works	from the manual	works	works	from the manual
IPO / preamp (AMP1, AMP2)	works	from the manual	works	works	from the manual
Manual notch	works	from the manual	works	works	from the manual
Noise blanker	works	from the manual	works	works	from the manual
Noise reduction (DNR)	works	from the manual	works	works	from the manual
RIT	works	from the manual	works	works	not offered yet
XIT	works	from the manual	works	works	not offered yet
VFOs and memories
Memory channels: add and edit (MT write)	works	-	-	-	-
Memory channels: list and recall	works	not offered yet	works	works	not offered yet
Quick split (QS)	from the manual, untested	from the manual	not offered yet	not offered yet	not offered yet
Split	works	from the manual	not offered yet	not offered yet	from the manual
VFO B (A=B, B=A, swap, set frequency)	works	from the manual	works	works	from the manual
Radio
144 MHz band	works	-	-	-	-
430 MHz band	works	-	-	-	-
amc_level	-	-	works	works	-
Antenna switching over CAT	-	-	-	-	-
audio_in_level	-	-	works	works	-
audio_out_level	-	-	works	works	-
C4FM mode (mode select only)	works	-	-	-	-
cw_keyer	-	-	works	works	-
cw_text	from the manual, untested	from the manual	works	works	from the manual
dual_receiver	-	-	works	works	-
menu	works	from the manual	works	works	from the manual
Power off over CAT	works	from the manual	works	works	from the manual
Power on over CAT (from standby)	works	from the manual	works	works	from the manual
range_scan	works	-	-	-	-
rear_select	-	-	works	works	-
scan	works	-	-	-	-
WIRES DG-ID menu value	works	-	-	-	-

Modes, bands and frequency range

	FT-991A	FTDX10	FTDX101D	FTDX101MP	FT-710
Modes	14: LSB, USB, CW-U, FM, AM, RTTY-L, CW-L, DATA-L, RTTY-U, DATA-FM, FM-N, DATA-U, AM-N, C4FM	14: LSB, USB, CW-U, CW-L, AM, FM, DATA-U, DATA-L, RTTY-L, RTTY-U, PSK, AM-N, FM-N, DATA-FM	14: LSB, USB, CW-U, CW-L, AM, FM, DATA-U, DATA-L, RTTY-L, RTTY-U, PSK, AM-N, FM-N, DATA-FM	14: LSB, USB, CW-U, CW-L, AM, FM, DATA-U, DATA-L, RTTY-L, RTTY-U, PSK, AM-N, FM-N, DATA-FM	14: LSB, USB, CW-U, CW-L, AM, FM, DATA-U, DATA-L, RTTY-L, RTTY-U, PSK, AM-N, FM-N, DATA-FM
Bands	160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m, 12m, 10m, 6m, AIR, 2m, 70cm	160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m, 12m, 10m, 6m	160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m, 12m, 10m, 6m	160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m, 12m, 10m, 6m	160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m, 12m, 10m, 6m
Frequency range	0.03-470 MHz	0.03-75 MHz	0.03-75 MHz	0.03-75 MHz	0.03-75 MHz
CAT identity (`ID;`)	`ID0670;`	`ID0761;`	`ID0681;`	`ID0682;`	`ID0800;`

Levels

	FT-991A	FTDX10	FTDX101D	FTDX101MP	FT-710
Level controls	AF Gain 0-255, RF Gain 0-255, Mic Gain 0-100, Squelch 0-100, TX Power 5-100	AF Gain 0-255, RF Gain 0-255, Mic Gain 0-100, TX Power 5-100	AF Gain MAIN 0-255, AF Gain SUB 0-255, RF Gain MAIN 0-255, RF Gain SUB 0-255, Squelch MAIN 0-100, Squelch SUB 0-100, Mic Gain 0-100, TX Power 5-100	AF Gain MAIN 0-255, AF Gain SUB 0-255, RF Gain MAIN 0-255, RF Gain SUB 0-255, Squelch MAIN 0-100, Squelch SUB 0-100, Mic Gain 0-100, TX Power 5-200	AF Gain 0-255, RF Gain 0-255, Mic Gain 0-100, TX Power 5-100

Not available on any of them (over CAT)

C4FM RX/TX DG-ID: not reachable over CAT (checked on a real FT-991A: no menu value changes). Only the WIRES DG-ID menu value is read.
Antenna selection: the FT-991A has no CAT command for it.
VOX is deliberately not offered: VOX plus remote audio is a risk of unintended transmission.
Memory writing: the program reads and recalls memory channels but never creates, changes or deletes one.

Where each status comes from: the capability files in backend/radio_remote/radio/capabilities/; the results of the real-radio tests are in bench results.